Protect natural stone around your Bunnell pool
Travertine Sealing in Bunnell, FL
Call (386) 337-3172 for a free estimate to seal the travertine at your Bunnell home.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get travertine sealed at my Bunnell home this month?
Yes, a local contractor seals travertine across Bunnell, FL, and replies within 1 business day, usually much sooner. The estimate is free, and you decide whether to book. To start the conversation, call (386) 337-3172.
Travertine is soft, pale and full of tiny holes, which is why it looks so good and why it stains so fast. A good sealing visit cleans it gently, treats the marks and soaks a protective coat into the stone. Picture the pool deck going from blotchy and dull to even and cool underfoot. Tell the contractor where the stone is when you request your free estimate.
Why does travertine need a different plan than concrete pavers?
Concrete pavers are made in a mold. Travertine is cut from the ground, with natural pores and voids that hold water, dirt and spilled drinks. A stone company in Key Largo says standard tile cleaners can ruin it for good, so the product choice matters before the first rinse. To talk through yours, call (386) 337-3172.
Pores and filler
Voids in the stone are usually filled at the factory. A Florida restoration company says that filler can loosen, shrink or pop out over time, leaving pits that trap dirt.
Acid sensitivity
Vinegar, lemon juice and many bathroom or driveway cleaners are acidic. One use can leave a dull ring, and repeat use can pit the surface.
Soft stone
High pressure can fracture it, erode the grout lines and drive grime deeper into the pores, so the cleaning method changes.
What is the process during a travertine sealing visit?
The order of work protects the stone. A contractor looks first, then cleans, then lets everything dry, and only then seals. If you would like the steps explained at your own deck, request your free estimate.
1. Look and test
The contractor checks the finish, the grout, the pits and how fast water soaks in. A small hidden spot gets tested before anything goes on the whole surface.
2. Gentle cleaning
A pH-neutral stone cleaner is worked in with a soft brush or a low-moisture machine, then rinsed until no film is left.
3. Stain and pit work
Oil gets a stone poultice. Pits are cleaned out and refilled with color-matched filler, after a small test area.
4. Dry time
Stone has to be dry before sealer goes on. Glaze 'n Seal, a sealer maker, asks for 24 hours of dry weather first, and 48 if the surface was just washed.
5. Penetrating sealer
The coat soaks in and leaves no film, then cures before chairs and feet come back.
6. Walk-through
You see the finished stone and get the cure and keep-off times for the product used.
Which sealer belongs on outdoor travertine?
Most outdoor travertine takes a penetrating sealer, the kind that soaks in without leaving a film. A Florida stone restoration company adds that outdoor stone needs a sealer rated for UV and salt air, because sun and moisture break sealers down and can bring up white mineral deposits. Ask for the product name and read its label together when you call (386) 337-3172.
Around the water, finish matters too. A honed, matte look is less slippery than gloss, and a sealer that adds traction helps where feet stay wet. Mention who uses the deck, from small kids to guests with canes, when you request your free estimate.
How do I know the sealer on my travertine has worn out?
Sprinkle a little water on the stone and watch it. If it beads, the coat is still working. If it soaks in and darkens the spot, the sealer is thin. Other signs are white mineral haze, green or black growth along damp edges and spots that no longer wipe clean. For a second opinion, call (386) 337-3172.
Natural stone does not follow one calendar. A Key Largo stone company says foot traffic, coastal exposure and the cleaners used between visits all move the date. A shaded deck behind pines may hold up longer than a sunny one. Share what your deck gets when you request your free estimate.
Will pool chemicals and well water mark my travertine?
Yes, both can. A Florida stone company says pool chemistry and acid products can damage travertine, so splashes should be rinsed off quickly and chemical jugs kept on a hard surface away from the stone. Iron is the other culprit, since UF/IFAS says most Florida well water is high in iron and leaves rust deposits on whatever it touches. To have orange marks checked, call (386) 337-3172.
Many homes outside town run on wells, and a sprinkler head that reaches the lanai stone will paint it orange over a summer. Moving the head is a job for the sprinkler installer, while the stain itself is a job for the contractor. Point out the worst spots when you request your free estimate.
Can travertine be pressure washed in Bunnell?
Not with a hard blast. One stone company says plainly, never high pressure, and another lists low pressure or a soft-wash method with a wide spray pattern and a moving wand. Western Interlock, a paver maker, keeps its pavers under 1,500 PSI, and travertine is softer than a concrete paver. Ask what pressure and what cleaner a contractor plans to use when you request your free estimate.
What does travertine sealing cost in Bunnell?
The honest answer is that the stone, the pits and the finish all move the price. Work from the published pieces and ask for each on its own line. Because natural stone takes more care than concrete, expect the upper half of the range if the deck has loose filler or stains. For a figure on your stone, call (386) 337-3172.
| Stone area | Typical example | Clean and seal at $1.50 to $3.00 a sq ft |
|---|---|---|
| 200 sq ft | Entry steps and front walk | $300 to $600 |
| 500 sq ft | Pool deck around a screened lanai | $750 to $1,500 |
| 900 sq ft | Deck, lanai and walk together | $1,350 to $2,700 |
No page opened for this site gave a rate for travertine alone, so this table is built from the published pieces that do exist: the $1.50 to $3.00 per square foot that Northeast Florida paver companies list to clean and seal (November 2026). Refilling pits and re-honing are priced after a look. One Florida stone care company charges a $250 assessment and credits it toward the work, which shows how a stone visit can be priced.
What does sealed stone and paving look like around Bunnell?
Where does travertine show up around Bunnell homes?
Mostly where people spend time outdoors: pool decks, lanai floors, entry steps and walkways. Bunnell is the Flagler County seat, with 3,276 people in the 2020 Census spread across about 140 square miles, so many lots are large and many pools sit behind screens in open yards. Mention the size of the lanai and the deck when you request your free estimate.
Pine and oak shade also matters here. Damp stone in a shaded corner grows green film first, and a Florida paver company lists algae on natural stone pool decks as a sign that service is due. A contractor can plan the cleaning order around those corners. To book a look, call (386) 337-3172.
Which nearby towns can get a travertine estimate?
A contractor covers the towns below as well as Bunnell. Pick yours, or request your free estimate and give your ZIP.
Frequently Asked Questions
Is it good to seal pavers in Florida?
For travertine the answer leans yes. The stone is porous, and sun, rain and pool splash get into it quickly. A penetrating sealer slows that without covering the natural look. The trade-off is a repeat visit every few years.
How often do you reseal travertine?
A stone care company in Florida says every few years, or sooner once water stops beading. A paver company puts most Florida homeowners at two to three years and says natural stone needs it more often than concrete or brick. Pool decks and open sun push the date earlier.
Can I use Dawn dish soap on travertine?
A few drops of mild dish soap in warm water is what one Florida stone company lists for routine cleaning, followed by a clean rinse. Vinegar, lemon juice and many bathroom or driveway cleaners are acidic and can leave dull rings. For anything beyond routine, ask the contractor.
How much does it cost to clean and seal travertine tile?
No travertine-only price turned up in the pages checked for this site. The published Northeast Florida range to clean and seal pavers is $1.50 to $3.00 per square foot, so a 500 square foot deck lands near $750 to $1,500 before any pit repair. Get the visit and the repair priced on separate lines.
Why is paver sealing so expensive?
Most of the price is labor, not sealer. Natural stone adds careful cleaning, low-pressure work and drying time before anything goes on. Rushing any of those steps is how a coat turns cloudy.
Does well water stain travertine in Bunnell?
It can. UF/IFAS says most Florida well water is high in iron, and iron leaves rust deposits wherever it lands. On pale stone the orange shows quickly, and a sealer coat can lock it in, so the stain gets treated first. To have a mark looked at, call (386) 337-3172.
Is a honed finish safer around a pool than a polished one?
A Florida stone restoration company says a honed matte finish is less slippery than high gloss and hides wear. Ask the contractor about a sealer finish that adds traction on wet areas. Grip matters more than shine at the water's edge.
Can travertine around a Bunnell pool be pressure washed?
Only gently. Two Florida stone companies warn that high pressure can fracture soft stone, erode grout and wash filler out of the pores. A low-pressure or soft-wash method with a wide spray pattern is what they describe.
What other paver services can I ask about in Bunnell?
Ready to protect the travertine around your Bunnell pool?
Call or send the short form, and you will hear back within 1 business day, usually much sooner.
Free, no obligation