Lift the green film, then refill every joint
Paver Cleaning and Joint Sand in Bunnell, FL
Ask for a free estimate to wash and re-sand your Bunnell pavers by calling (386) 337-3172.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my pavers cleaned in Bunnell without a long wait?
A local contractor cleans pavers across Bunnell, FL, and you will hear back within 1 business day, usually much sooner. New joint sand is part of the work, and the free estimate carries no pressure to book. To start, call (386) 337-3172.
Cleaning lifts the algae, rust, leaf stains and dirt that dull pavers, so the surface looks brighter and grips better underfoot. New sand goes into the joints afterward, so pavers stop shifting and weeds find less to hold onto. The back patio under the oak that went dark over the summer can match the rest of the yard again. Show the contractor which spots look worst when you request your free estimate.
Paver Sealing Bunnell Is Proud to Serve Northeast Florida
What is part of a paver cleaning job?
Expect an algae treatment, stain work, a controlled wash and new joint sand once everything dries. Some people book it alone, and others treat it as the first half of sealing. Walks under trees and corners where sprinklers hit tend to take the most hours. To line up a cleaning, call (386) 337-3172.
Algae treatment
A cleaner goes on before the wash to loosen green and black growth, so less force is needed.
Stain work
Rust, leaf stains and oil each get a product meant for that stain, tried first on a small corner.
Controlled wash
A rotary surface cleaner covers the area evenly, and the pressure stays low enough to keep the joint sand in place.
Joint sand
Dry sand is swept into each gap once the pavers have dried, then settled. A sealer coat can follow, as the sealing guide explains.
What are the signs my pavers need cleaning?
Look for a green or black film along shaded edges, orange marks near sprinklers, weeds in the joints, brown leaf stains and sand spread across the driveway after rain. Green film leads the list because a slippery walk or pool deck can cause a fall. To have yours looked at, call (386) 337-3172.
Is cleaning enough, or should I seal my pavers too?
Cleaning changes how pavers look now, while sealer influences how long they stay that way. Stopping at the wash costs less now, but algae, rust and fading return on their own schedule. Sealer speeds up later cleanings, though it must be renewed every few years. Say which you want when you request your free estimate.
How often should Bunnell pavers be cleaned?
Family Handyman suggests cleaning pavers about once a year, in spring, and that rhythm fits most homes. Walks under oaks and spots near sprinkler heads may need attention sooner, while an open, sunny driveway can wait longer. To plan a cleaning rhythm for your own yard, call (386) 337-3172.
Does a harder blast clean pavers better?
No. Western Interlock, a paver maker, says to keep washing pressure under 1,500 PSI, and spraying hard into the joints pulls the sand out. A surface cleaner held at a steady height gives an even result, and the cleaner you choose does the lifting. Ask what pressure the contractor runs when you request your free estimate.
Runoff matters too. Ask where the wash water goes and how plants and screens get covered, since cleaners should stay off landscaping. How a contractor answers those two questions says a lot about the care to expect. To ask them now, call (386) 337-3172.
Why do leaf stains show up on my pavers?
Leaves that sit on wet pavers leave brown marks, because Western Interlock, a paver maker, says tannins in the leaves stain the surface. Sweeping or blowing them off early prevents most of it. For stains already set, the same company says hot water lifts organic marks. Point out the spots when you call (386) 337-3172.
What are the orange stains near my sprinklers?
Most often it is iron. UF/IFAS says most Florida well water is high in iron, and it leaves rust deposits on whatever it touches, concrete pavers included. A rust remover made for pavers lifts the stain, and it has to come off before any sealer goes on. Show the contractor the marks when you request your free estimate.
Why are white patches showing on newer pavers?
A chalky white film on newer pavers is usually efflorescence, natural salts working out of the concrete. Unilock, a paver maker, says it has to be cleaned off and the surface dried before any sealer goes on. Cloudy old sealer can look similar, which is why a look in person helps. Let the contractor see that spot when you call (386) 337-3172.
Which paved areas can be cleaned at a Bunnell home?
Driveways, pool decks, patios and walks can all be washed, and nothing paved at the house is left out. Each collects a different kind of dirt, so the cleaner and the method change. To start with yours, request your free estimate.
Driveways
Tires, oil drips and afternoon sun hit the driveway before anything else. Cleaning here puts the most effort where cars turn and the joints loosen.
Pool decks and screened lanais
Bare feet, splashing and pool chemicals make a deck wear differently from a drive. Cleaning around a pool should leave the surface able to drain, with grip underfoot.
Back patios under oaks
A patio under a tree stays damp longer and collects leaves, so it greens up first. Cleaning a shaded patio focuses on the damp corners and the leaf stains.
Front walks and entries
The front walk meets potted plants, mulch and sprinkler spray. Cleaning it takes little time, and it is the first paving a visitor steps on.
What leaves Bunnell pavers dirty?
Sun fading, shade, well-water rust, leaf stains and rain-washed sand lead the list. A wash clears some of these, while others need a coat of sealer or a repair. To see which ones fit your home, call (386) 337-3172.
1. Fading on open driveways
Bunnell has a humid subtropical climate with hot summers, and a drive with no shade takes that sun all day. The wash shows how much color remains, and sealer afterward helps it last.
2. Green film in oak shade
Under oaks, humid air keeps pavers damp for hours after rain. A green or black film starts at the shaded edges and spreads along the walk.
3. Orange marks from well-water sprinklers
UF/IFAS says most Florida well water is high in iron, and iron leaves rust deposits where the spray lands. Those marks need a rust remover, because more pressure will not lift them.
4. Leaf stains
Western Interlock, a paver maker, says tannins in fallen leaves leave stains when the leaves sit. Sweeping early keeps a stain from setting.
5. Joint sand washed out by rain
A Flagler County paver company says rain removes the sand that keeps pavers from shifting. Once joints run low, pavers wobble and weeds get a foothold.
What does paver cleaning cost in Bunnell?
A wash on its own costs less than the full job, because it skips the sealer. No local wash-only rate was published where this site looked, so the honest answer is to ask for one. Have the contractor list the wash, the joint sand and any stain treatment on separate lines. For a price on your property, request your free estimate.
Planning to seal after the wash? Ask for a single price that covers both. Northeast Florida companies publish $1.50 to $3.00 per square foot for the full clean, sand and seal. To talk through the two side by side, call (386) 337-3172.
Thinking about protection too? The paver sealing guide covers it, the service areas page lists the towns, and paver sealing in Bunnell is on the home page.
| Paved area | Typical example | Wash, sand and seal together |
|---|---|---|
| 400 sq ft | Back patio | $600 to $1,200 |
| 800 sq ft | Standard driveway | $1,200 to $2,400 |
| 1,200 sq ft | Long drive or pool deck | $1,800 to $3,600 |
The table uses the $1.50 to $3.00 per square foot that Northeast Florida paver companies published as of November 2026. A wash alone is not priced here, because no local wash-only rate was published. Ask the contractor to list the wash, the sand and the sealer on separate lines.
Why use a contractor who works around Bunnell for paver cleaning?
A contractor who covers Flagler County knows what oak shade, rain and iron in well water leave behind. You can compare the quote with the published rates on this page and decide on your own time. To begin, request your free estimate.
A contractor who works around Bunnell
A local contractor who covers your part of Flagler County has handled the same sun, rain and oak shade your pavers sit in. The first visit goes faster because of that.
A free look, then a price
Getting an estimate is free, and saying no afterward is fine. If the number is not right for you, you can say no and move on.
Published rates to check against
Companies in the region post what they charge per square foot, and this site shows those ranges. If a bid sits far above or below those numbers, ask why.
You choose when and who
Ask for the price in writing and decide at your own pace. Before you say yes, read the contractor standards page to see what to check.
Want a free estimate to clean your Bunnell pavers?
Use the short form or phone, and you will hear back within 1 business day, usually much sooner.
Free, no obligation
What do cleaned pavers look like around Bunnell?
How does the paver cleaning process go, step by step?
When no sealer is wanted, the job finishes at step four with full joints. To set a date, call (386) 337-3172.
1. Measure and look it over
The contractor takes measurements so the cleaning job can be priced. Low spots, loose pavers, old sealer and any place water pools get noted.
2. Treat and wash
An algae treatment goes on first, then a rotary surface cleaner runs over the pavers. Western Interlock says to keep washing pressure under 1,500 PSI so the joints survive.
3. Spot treat the stains
Iron marks get a rust remover, and leaf stains get hot water or a cleaner made for organic stains. Each is tried on a small corner before it goes on the full surface.
4. Fill the joints
Once the pavers are dry, dry sand is swept in, settled with a compactor or a hose mist and topped off. Extra sand is swept away.
5. Seal and walk the job
If sealer is part of the job, a pump sprayer applies it and a foam roller evens it out, at the coverage on the label. Unilock puts that at 80 to 120 square feet per gallon. Last, the contractor goes over the finished area with you and tells you how long to keep off it.
Frequently Asked Questions
Is it a good idea to pressure wash pavers?
Yes, as long as the pressure stays low and new sand goes into the joints. Western Interlock, a paver maker, says to stay under 1,500 PSI, because harder spray empties the joints and can scar the surface. A rotary surface cleaner and a cleaner matched to the stain do more than raw force.
Should you seal pavers after power washing?
It is optional, though dry pavers still need fresh sand in the joints. A coat after the sand goes in helps hold it through summer rain and makes the next cleaning easier. The surface has to be fully dry first, and Glaze 'n Seal, a sealer maker, says that can mean 48 hours.
How much does it cost to re-sand and seal pavers?
Northeast Florida companies publish about $1.50 to $3.00 per square foot for the full clean, sand and seal, so the sand is already in that number. A 600 square foot driveway comes to roughly $900 to $1,800. Make sure joint sand shows up as a line in your quote.
How much does it cost to have pavers cleaned and sealed?
At published Northeast Florida rates of $1.50 to $3.00 per square foot, an 800 square foot driveway runs about $1,200 to $2,400. Stripping old sealer and leveling sunken pavers are usually extra. Ask for the wash, the sand and the sealer on separate lines.
How much should I pay for paver sealing?
A fair quote usually lands inside the $1.50 to $3.00 per square foot range companies in this region publish. A bid far below it often skips the wash or the joint sand. Before you compare two prices, find out what each one includes.
Is there a pressure washing business in Florida?
Yes, many do, and some also clean pavers, re-sand them and seal. Ask whether the company uses a surface cleaner, what pressure it runs and whether new joint sand is in the price. A contractor who works around Bunnell can answer all three.
Is it good to seal pavers in Florida?
Usually, once they have been washed and the joints refilled. Sun, humidity and rain fade color and loosen sand, and a coat slows all three. It is a repeat job every few years, which is the trade-off.
Will the orange stains from my well-water sprinklers wash off in Bunnell?
A plain wash may not lift them. UF/IFAS says most Florida well water is high in iron, and iron leaves rust deposits wherever the spray lands. A rust remover made for pavers goes on first, and more pressure only risks the joints.
How do I get green film off shaded pavers in Bunnell?
Shade and damp air feed it, so an algae treatment before the wash does more than scrubbing. Under oaks, the film can return within a season. A sealer coat afterward makes the surface easier to rinse.
Tired of green film and stains on your pavers?
A quick request gets a free look from a local contractor, with a reply inside 1 business day and usually much sooner.
Free, no obligation