Dark, even color from the road to the garage
Driveway Paver Sealing in Bunnell, FL
Get a free driveway paver sealing estimate in Bunnell by calling (386) 337-3172 today.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Does a local contractor reach my Bunnell driveway, and how soon?
A local contractor seals paver driveways all around Bunnell, FL, and you hear back inside 1 business day, usually much sooner. The estimate is free, and you decide whether to book. To get started, call (386) 337-3172.
Think about the last 20 feet before your garage, where tires turn and a truck drips every morning. That patch usually fades first and collects the stains, while the rest of the drive looks fine. A wash, fresh sand and sealer even it out and make the next hose-down easier. Say how long your drive runs when you request your free estimate.
What does a Bunnell paver driveway cost to seal?
A Volusia County paver company lists driveways at $1.50 to $2.50 per square foot and says typical driveways run 400 to 1,200 square feet. At those rates the job costs $1,000 to $3,000. The table puts the same rate on five Bunnell lot sizes. To get a price for your drive, request your free estimate.
Size is the first driver, and the second is what is on the surface today. Oil spots, sunken edges and sealer that has started to flake add labor. Holding a bid already? Call (386) 337-3172 and see whether it lists the wash, the sand and the coat separately.
| Driveway size | What it looks like | At $1.50 to $2.50 per sq ft |
|---|---|---|
| 400 sq ft | Single car drive | $600 to $1,000 |
| 600 sq ft | Two car drive in a subdivision | $900 to $1,500 |
| 900 sq ft | Wide drive with a turnaround | $1,350 to $2,250 |
| 1,200 sq ft | Three car drive or a long drive | $1,800 to $3,000 |
| 2,000 sq ft | Long drive back from a county road | $3,000 to $5,000 |
Driveway rate published by a Volusia County paver company, as of November 2026. The 2,000 square foot row applies the same rate and is not a quoted job. Stripping old sealer and resetting low pavers usually cost extra.
Which towns near Bunnell get driveway estimates?
The service area runs well past Bunnell, with a page for every town below. Call (386) 337-3172 if yours is missing.
Why do long driveways in Bunnell cost more to seal?
Bunnell covers about 138.6 square miles, according to Wikipedia, so many homes sit on long drives back from the road. More length means more square feet, and square feet drive the price. A drive that passes 1,000 square feet can fall in the $1,500 to $2,500 range at published rates. To describe yours, request your free estimate.
Length also changes the setup. The contractor may need a longer hose run, a spot to stage equipment and a plan for working in sections so the whole drive is not blocked at once. Ask how a drive that serves a barn or a boat will be handled. Bring that up when you call (386) 337-3172.
Do pine needles, oak leaves and sandy soil hurt a paver drive?
They can, in different ways. Leaves and needles that sit on wet pavers leave brown tannin marks, and sweeping them off early prevents most of it. A coat of sealer keeps debris on the surface instead of in the pores. For stains already set, point them out when you request your free estimate.
Rain is the other piece. A driveway sheds water toward its edges, and that flow can pull sand out of the joints and leave pavers loose near the edges. Ask the contractor to look at the low spots when you call (386) 337-3172.
How hard do summer storms push the sealing date?
Harder than you might expect. Alliance says to wait 48 hours of dry weather after rain before sealing, and Unilock wants clear skies for 24 to 48 hours beforehand. Flagler County averages close to 50 inches of rain a year, according to News4Jax,. Ask how a rain delay is handled before you book, or call (386) 337-3172.
Which finish suits a driveway: natural, satin or wet look?
A driveway is where tires meet the surface, so grip counts. Alliance says the natural look adds about 5 percent to color, while satin and wet looks change it more and feel slicker underfoot. Unilock says high gloss is slippery when wet, so a satin or matte finish suits a drive that gets rain and hose water. To compare finishes in person, request your free estimate.
Solvent and water-based products also differ. Unilock gives solvent sealers 80 to 120 square feet per gallon and water-based ones 100 to 150, with both at $80 to $150 a gallon. Alliance warns that a water-based coat can never go over a solvent one. Tell the contractor what is on the drive now when you call (386) 337-3172.
How soon do pavers need sealing again after a coat?
Three to five years is the usual answer. Unilock says to reseal every three to five years, and Superior Brick Pavers says no more often than that, since too many coats can leave a milky haze and peel. Signs it is time are water soaking in and darkening the paver instead of beading. Have yours checked by calling (386) 337-3172.
What do sealed driveways look like around Bunnell?
What is the process on a Bunnell driveway sealing visit?
Five steps cover most drives, and each one has a reason. To book a date, call (386) 337-3172.
1. Measure the drive and read the surface
The contractor measures length and width, then walks it for oil spots, loose pavers, low edges and old sealer that is flaking.
2. Clear and wash
Vehicles come off, plants along the edges get covered, and the surface is washed so the joints stay intact.
3. Treat oil, rust and leaf marks
Oil under the usual parking spot gets a degreaser, iron marks from sprinklers get a rust remover and leaf stains get their own cleaner.
4. Dry and refill
After a full dry, sand goes into the joints and the surplus is swept away so none stays on the face of the pavers.
5. Seal and mark the keep-off time
The coat goes on in thin, even passes at the label rate. You get a day and hour for feet, then another for tires.
Driveway questions Bunnell homeowners ask
How much should it cost to seal a paver driveway?
A Volusia County paver company lists driveways at $1.50 to $2.50 per square foot and says its typical driveways run 400 to 1,200 square feet at $1,000 to $3,000. A two car Bunnell drive near 600 square feet would land around $900 to $1,500 at that rate. Ask for the square footage and the rate on the quote itself.
What is the average cost to seal pavers in Florida?
Published Northeast Florida rates run $1.50 to $3.00 per square foot for the whole job of washing, sanding the joints and sealing. Driveways sit in the lower half of that range, and pool decks in the upper half. Stripping old sealer or resetting sunken pavers is usually billed on top.
Is there a downside to sealing pavers?
A few. It is a repeat cost every few years, and a glossy coat can feel slick when wet. Superior Brick Pavers adds that too much sealer builds up into a milky haze and can peel. A thin coat on dry pavers, with a satin finish for a drive that tires wet down, avoids most of that.
How long do paver sealers last?
Expect three to five years from most coats, with solvent-based products at the long end. Alliance, a sealer maker, lists solvent finishes at 3 to 5 years and water-based hybrids at 2 to 3. A drive that gets sun all day and heavy truck traffic will not last as long as a shaded one.
How long before I can park on a sealed driveway?
Alliance says to wait 24 hours before walking or driving on a sealed surface, and Unilock says the coat can take up to 48 hours of dry weather to cure. Bunnell afternoon storms can stretch that. Park on the street or the lawn until the contractor says the drive is ready.
Do I need to move my boat trailer or truck before the job?
Yes, everything comes off the pavers for the wash and stays off through the keep-off time. Ask the contractor for the exact day you need the drive clear and when it opens again. A trailer that has to be back on a schedule is worth mentioning at the estimate.
My Bunnell driveway is over 100 feet long. Does that change anything?
It changes the square footage first. A long drive back from a county road can pass 2,000 square feet, and at $1.50 to $2.50 that is roughly $3,000 to $5,000. The contractor may also need a longer hose run or a water source near the far end.
Will pine needles and oak leaves stain a sealed driveway?
A coat helps, since debris and tannins stay on the surface where a blower or hose can reach them. Fallen leaves that sit wet for weeks can still leave a mark. Sweeping them off early is the habit that matters most.
Can a driveway be resealed over an old coat?
Often yes, with one firm rule. Alliance says a water-based sealer can never go over a solvent-based one, while a solvent product can go over either. Tell the contractor what you remember about the last coat when you ask for a quote.
Ready to see the driveway dark and even again?
Use the short form or call, and an answer arrives within 1 business day, often sooner.
Free, no obligation